Publication

Real-Time Current Estimation in Brushless DC Drives using a Single DC-Link Sensor (1993)

Author(s): P.P. Acarnley;C.D. French;A.G. Jack

  • : Real-Time Current Estimation in Brushless DC Drives using a Single DC-Link Sensor

Abstract: The classical method of current control in a three phase inverter is to compare current demand with actual winding current, where the winding current is obtained by direct measurments on the motor windings. This method of current measurement relies upon total uniformity of current sensors, to achieve a balanced output. The problem of current sensor imbalance can lead to unacceptable torque ripple at low speeds. By using a single sensor located on the dclink, there is inherent balance. Due to the chopping action of the inverter, current cannot always be directly measured at the dclink. This paper describes an observer based system that uses a motor / converter model to estimate this flywheeling current. When the winding current can be directly measured at the dclink, the observer updates its system model in a closed loop manner. The observer is implemented in real-time using a DSP ( Digital Signal Processor ) based system. Full steady-state & transient results are described.

  • Short Title: Real-Time Current Estimation in Brushless DC Drives using a Single DC-Link Sensor
  • Conference Name: European Power Electronics Conference
  • Publisher: EPE
  • Publication type: Conference Proceedings (inc. abstract)
  • Bibliographic status: Published
    Staff

    Professor Alan Jack
    Emeritus Professor